SecurityMan OutdoorWatch Series User's Guide download pdf (Page 18)

B) Setting up the Camera

1) Set the camera to desired Dip-Switch Channel

2) Place the camera at desired location.

3) Plug the power adapter jack into the power jack

4) Plug the power adapter to any DC outlet

5) Mark down the Dip-Switch Channel of each camera. (The receiver

will receive signal from camera’s corresponding Dip-Switch Channel

and display in different channels. For example, Channel 1 on the

TV/Monitor will display the image from Camera 1 only).

Note: The OutdoorWatch4 cameras’ Dip-Switch settings has been pre-

set to 4 different channels (Ch1 to Ch4). Each camera is desig

nated with its own channel

C) Setting up the Receiver

1) Basically, the receiver is already set to match the camera in factory

default. Therefore, receiver will only need to set up if more than one

camera is used. Follow the instruction in “Dip-Switch (Receiver)” to

set the receiver to receive signal from more then one camera.

ON GDH02

Power Jack

Switch

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

No comments

SecurityMan OutdoorWatch Series User's Guide Page 18