SecurityMan iCamDVR User Manual download pdf (Page 32)

Figure 44 - E-map Edit

Figure 45 - Emap CAM1~4 Installation

31 | SecurityMan

Emap Edit

Start by nding an ideal geographic picture(s) of the

region or building where SuperDVR is located. Save the

picture(s) le in a form bitmap (.bmp) or .jpg format into a

folder, i.e. “c:\superdvr”. Be sure to jot down this geograph-

ic location “c:\superdvr” for easy retrieval when editing the

Emap Edit.

Right-click on any part of the default virtual building to

select “Load Picture” as illustrated in gure 44 below.

Browse for the geographic picture i.e. c:\superdvr to select

the ideal picture region or building map. Then open the

picture le and the picture le will display in this interface

in a form of a map as shown below. This virtual building

region below may apply to other resemblance regional

areas; other geographic area picture may apply.

Click hold and drag CAM1, CAM2, CAM3 and CAM4 icons

of cameras located at the left column to the corresponding

position on the map. Right click on any part of the build-

ing to select “Save Map” to save map setting. To change

icon of the CAM1~4 right click on the CAM1~4 icon and

select “Change icon” or select “Delete” to remove the cam-

era from Emap, as illustrated in gure 45 below.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 82 83

No comments

SecurityMan iCamDVR User Manual Page 32