SecurityMan iCamDVR User Manual download pdf (Page 41)

Figure 59 - Preset and GROUP select

Figure 60 - Preset & GROUP Conguration

40 | SecurityMan

Start by clicking on the Group Setting button

to dierentiate and separate the presets into group(s). De-

cide how many of the 16 preset are to be in GROUP1, how

many preset are to be in GROUP2 and so on. For example;

by selecting GROUP1 from the drop down list and then

placing a check mark in front of Preset1, Preset2, Preset3,

Preset4 and Preset5 means that the rst 5 preset belongs

to GROUP1 as illustrated below in gure 61. Finally set-

ting up the Dwell time by inputting a number to represent

the number of seconds that will take for GROUP1 presets

(rst 5 preset) to rotate when GROUP1 becomes active and

click on SAVE to save the settings. Setup GROUP2~4 by

following the same procedures as in the example above.

Any one GROUP can be enabled by selecting GROUP1~4

from gure 59 to start auto dwelling.

When GROUP is active all the selected preset1 through

preset5 will auto dwell in sequence if GROUP1 were to

be selected or select any of the 16 preset to view the x

preset position.

Click button to exit out of GROUP setting

and get back to the Preset setting as shown in gure 60.

In Preset setting press the “Choose a Preset” button to

select 1 of the 16 preset positions and then the name of

the Preset location will appear under “Name”. The “Name”

can be change by typing the new name into the name

eld. Next is to manually control the PTZ camera image to

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 82 83

No comments

SecurityMan iCamDVR User Manual Page 41